Hi AFTERE I finish simulation and synthsis with some board how I move to mass production , how I program that design into say 1000 FPGA chips? Elico
Elico C. wrote: > how I program that design into say 1000 FPGA chips? how do you program it into 1 FPGA? For 1000 FPGAs repeat this 1000x Simple. Isn't it? It does realy pay of to use a suitable connector on your PCB.
Another way is to solder pre-programmed config PROMs onto the PCB. That's my preferred solution.
:
Edited by Moderator
Watch this topic
Disable multi-page view