Forum: FPGA, VHDL & Verilog gpio pull-down

von demsp (Guest)

Rate this post
0 useful
not useful
How can i pull-down a pin on my cpld-board(MAXII EPM)? Is there this 
pull-up resistors(on board)? Where is the "resource property editor" in 
my QuartusII?

von demsp (Guest)

Rate this post
0 useful
not useful
There is "Weak Pull Up" in Menu/Assignments/Assignments Editor.
Is there "Weak Pull Down" somewhere?

von Duke Scarring (Guest)

Attached files:

Rate this post
0 useful
not useful

In MAX II there are only programmable pull-up resistors.
If you need pull-down, just take a soldering iron.



Entering an e-mail address is optional. If you want to receive reply notifications by e-mail, please log in.

Rules — please read before posting

  • Post long source code as attachment, not in the text
  • Posting advertisements is forbidden.

Formatting options

  • [c]C code[/c]
  • [avrasm]AVR assembler code[/avrasm]
  • [vhdl]VHDL code[/vhdl]
  • [code]code in other languages, ASCII drawings[/code]
  • [math]formula (LaTeX syntax)[/math]

Bild automatisch verkleinern, falls nötig
Note: the original post is older than 6 months. Please don't ask any new questions in this thread, but start a new one.