Forum: FPGA, VHDL & Verilog FPGA EEPROM erasing

von Hareesh M. (Company: Mindteck) (hareeshp)

Rate this post
0 useful
not useful
i have done the active serial programming by switching the mode from 
JTAG to Active Serial Programming, and it works fine.For erasing the 
EEPROM of fpga, i put checked the erase box in the configuration and the 
configuration switch into to the PROG mode. After the successful erasing 
the fpga board, and i can't do any programming on it.

Please anyone tell me the erasing procedure for cyclone ii fpga.


Entering an e-mail address is optional. If you want to receive reply notifications by e-mail, please log in.

Rules — please read before posting

  • Post long source code as attachment, not in the text
  • Posting advertisements is forbidden.

Formatting options

  • [c]C code[/c]
  • [avrasm]AVR assembler code[/avrasm]
  • [vhdl]VHDL code[/vhdl]
  • [code]code in other languages, ASCII drawings[/code]
  • [math]formula (LaTeX syntax)[/math]

Bild automatisch verkleinern, falls nötig
Note: the original post is older than 6 months. Please don't ask any new questions in this thread, but start a new one.