Hello! Are there any available PmodNIC100 drivers for Basys3 to connect it via ethernet cable to a computer. I am a beginner and do not have the knowhow to write this interface by myself in a reasonable time for my project. I program in ISE Design Suite 14.7 enviroment and use VHDL. I am kindly open to any recommendations.
Guest
#4069070
The Basys3 contais an FPGA. An FPGA is not automatically a microproocessor. So what you called 'driver' is in FPGA world called 'IP core'. An ethernet IP core is not a project for a bloody beginner. What experience did you have with designing for FPGA? Duke
I know what FPGA is and have had few courses where I have programmed NEXSYS 1, BASYS 1 and BASYS 2. I have not used any addons for these devices. My current project is to send data form computer to a BASYS 3 board, encrypt this data with AES and then send the ecrypted data back to computer. I am looking for a simple or the simplest way to simulate ethernet conection between my computer and FPGA device. I ask about PmodNIC100 because this is a device available for me.