ATmega - ISP Mkii - Newbie

Crank Guest #2853592
Rate this post
• ▲ useful
▼ not useful 
Hello everybody.

First of all I am a total newbie, so the issue can be very obvious.
In the attachment you can find my build up.

Well my first step was to start AVR Studio to select my programmer (ISP 
Mkii) and then the µc (ATmega8-16pu -> Atmega8 ??) and then I get the 
error message "target voltage 0,0V".

That's it, any ideas ?

Ps. Sry for my english :)
Attached files:
Reply Quote Edit Move Thread sperren Anmeldepflicht aktivieren Anpinnen Delete topic Thread mit anderem zusammenführen Report post
g457 Guest #2853599
Rate this post
• ▲ useful
▼ not useful 
Looks like you mixed up ('mirrored') your isp pinout.

Pin 1 on the connector is where the small arrow next to the red wire 
(from the ribbon cable) points to. This should be the pin in the 
top-right corner in your photo (which is connected to VCC instead of 
MISO).

Double-check that.

HTH
Reply Quote Edit Delete Report post
Watch this topic

Reply

A question of your own? This thread is over 14 years old. Ask it in a thread of its own – more people read along there, and it gets answered more often and sooner.

Start a new thread

A fix, an addition or feedback on this thread? Then reply here.

Formatting
  • [c]C-Code[/c]
  • [code]code in other languages, ASCII drawings[/code]
  • [math]formula (LaTeX syntax)[/math]
  • [[Title]] – link to an article
  • Link to another post: right-click its post ID (#8078628), copy the address, paste it into the text

More about formatting

Post long source code as an attachment, not in the text.

Your name and e-mail address

Already registered? Log in

Not shown to anyone. We send you a link; your post appears once you confirm it there.

By submitting you create a free account and accept the terms of use.