# Forum: ARM programming with GCC/GNU tools .cmd files?

Rate this post
 0 ▲ useful ▼ not useful
Hello,

I would like to follow the Martin Thomas step-by-step guide to
"Wiggling"; however, he references two .cmd files in the "source
archives" that I have not been able to locate.

Does anyone know what the "source archive" is that he is refering to or
where I can find examples of these .cmd files?

start_wiggler.cmd
start_insight.cmd

I am hoping to eventually get Eclipse working with an Olimex LPC-P2129
development board and have not had success getting the debugger up and
and running.

Thanks for any hints!

Rate this post
 0 ▲ useful ▼ not useful
Bubba Glade wrote:
> Hello,
>
> I would like to follow the Martin Thomas step-by-step guide to
> "Wiggling"; however, he references two .cmd files in the "source
> archives" that I have not been able to locate.

This guide is outdated. Back from the time when OpenOCD did not exist.
It's mentioned on the page.

> Does anyone know what the "source archive" is that he is refering to or
> where I can find examples of these .cmd files?
>
> start_wiggler.cmd
> start_insight.cmd

old text/files. Use OpenOCD.

> I am hoping to eventually get Eclipse working with an Olimex LPC-P2129
> development board and have not had success getting the debugger up and
> and running.

Please search for the Eclipse ARM guide from Jim Lynch. There are two
version, one features AT91SAM7 the other LPC2000. The concepts are the
same but the LPC2000-guide might be easier to follow/reproduce with you
hardware.

• $formula (LaTeX syntax)$