Forum: µC & Digital Electronics Program download issue

von Prakash R. (Company: Coinel Technology Solutions) (prakash)

Rate this post
0 useful
not useful

I am downloading the program on LPC1768 target board using CoiNel 
ARM-USB-JTAG through Keil micro-vision 4.03. After programming, target 
board going to reset mode. The programmed code will work only after 
unplug the USB cable which is connected to the CoiNel ARM-USB-JTAG.

Is there any setting have to do on Keil IDE?

Many thanks in advance.


Entering an e-mail address is optional. If you want to receive reply notifications by e-mail, please log in.

Rules — please read before posting

  • Post long source code as attachment, not in the text
  • Posting advertisements is forbidden.

Formatting options

  • [c]C code[/c]
  • [code]code in other languages, ASCII drawings[/code]
  • [math]formula (LaTeX syntax)[/math]

Bild automatisch verkleinern, falls nötig
Note: the original post is older than 6 months. Please don't ask any new questions in this thread, but start a new one.