Forum: ARM programming with GCC/GNU tools USART is Not working

von Mukesh K. (mukeshtalks)

Attached files:

Rate this post
0 useful
not useful
Hello All,

I am very new to SAM7A3 controllers. I have AT91SAM7A3 evaluation kit
with me. I installed YOGARTO tol chain and IDE. I created one new
project on that for printing "HELLO" on USRAT. Its not working can you
please tell me Am I doing fine or wrong. I attached my Complete project
file in the attachment. So please suggest where is the problem.
 I hope for positive response from your side.



Entering an e-mail address is optional. If you want to receive reply notifications by e-mail, please log in.

Rules — please read before posting

  • Post long source code as attachment, not in the text
  • Posting advertisements is forbidden.

Formatting options

  • [c]C code[/c]
  • [avrasm]AVR assembler code[/avrasm]
  • [code]code in other languages, ASCII drawings[/code]
  • [math]formula (LaTeX syntax)[/math]

Bild automatisch verkleinern, falls nötig
Note: the original post is older than 6 months. Please don't ask any new questions in this thread, but start a new one.