Forum: ARM programming with GCC/GNU tools reset problem

von Suresh K. (sureshkumar)

Rate this post
0 useful
not useful
now i am working with LPC2292 .I am using GNU gcc compiler.
I have an one problem.

My Project:
       lpc2292 interface with eithernet controller(RTL8019as).

1. i have developed the code, upload my hex file through lpc2000
After upload is completed, i am changing the mode to execuation and
pressed reset button. Code is executed sucessfully. But i am power off
my kit and again powered is on. That time my code is properly execuated.

what is the reason. What are the initial conditions are made? please
tell to me.

2. And also i need lpc2292 linker file(.ld)

3. another one doubt,
    using on chip flash booting, can i interface external data
memory(like ram)? If yes please tell me the procedure.


Entering an e-mail address is optional. If you want to receive reply notifications by e-mail, please log in.

Rules — please read before posting

  • Post long source code as attachment, not in the text
  • Posting advertisements is forbidden.

Formatting options

  • [c]C code[/c]
  • [avrasm]AVR assembler code[/avrasm]
  • [code]code in other languages, ASCII drawings[/code]
  • [math]formula (LaTeX syntax)[/math]

Bild automatisch verkleinern, falls nötig
Note: the original post is older than 6 months. Please don't ask any new questions in this thread, but start a new one.