EmbDev.net

Forum: µC & Digital Electronics Some change for the boot logo


Author: Brittany Snow (brittany_snow)
Posted on:

Rate this post
0 useful
not useful
I want to change the boot logo on SBC6000 board(from Embest). So how can 
I do it?

Author: ... (Guest)
Posted on:

Rate this post
0 useful
not useful
here you have got your answer :
http://www.edaboard.com/thread224064.html

Author: Brittany Snow (brittany_snow)
Posted on:

Rate this post
0 useful
not useful
Sorry, I make a mistake about that. What I want to know is below:

How to change SBC6000X default configuration with 4.3 inch LCD to other 
size LCD ?

Maybe today I was nervous in the new forum and post wrong thing. Well, 
thank you for your attention.

Author: ... (Guest)
Posted on:

Rate this post
0 useful
not useful
> How to change SBC6000X default configuration with 4.3 inch LCD to other
> size LCD ?

you have to change it in the Linux hardware-configuration.

Author: Brittany Snow (brittany_snow)
Posted on:

Rate this post
0 useful
not useful
And how? I always used is 4.3"LCD, and my LCD is bad now and I want to 
use another 7"LCD, so how did it? Do you have some instructions for it?

Author: ... (Guest)
Posted on:

Rate this post
0 useful
not useful
I think the Linux-system on the board is the embedded-Linux buildroot.

http://buildroot.uclibc.org/

So you have to built a new Kernel with the changed 
hardware-configuration.

Author: ... (Guest)
Posted on:

Rate this post
0 useful
not useful
Ok, forget what I say. Here is the answer:
http://www.embedinfo.com/cforum/arm_forum_moredata...

Author: Brittany Snow (brittany_snow)
Posted on:

Rate this post
0 useful
not useful
Where did you find this? Stangly, I never find it. after I bouth the 
boards, I just take a look on this web: http://www.armkits.com/. Well, 
thank you very much for your information.

Reply

Entering an e-mail address is optional. If you want to receive reply notifications by e-mail, please log in.

Rules — please read before posting

  • Post long source code as attachment, not in the text
  • Posting advertisements is forbidden.

Formatting options

  • [c]C code[/c]
  • [avrasm]AVR assembler code[/avrasm]
  • [code]code in other languages, ASCII drawings[/code]
  • [math]formula (LaTeX syntax)[/math]




Bild automatisch verkleinern, falls nötig
Note: the original post is older than 6 months. Please don't ask any new questions in this thread, but start a new one.