EmbDev.net

Forum: ARM programming with GCC/GNU tools New to Sam7 and Yagarto


Author: Mukesh Kumar (mukeshtalks)
Posted on:

Rate this post
0 useful
not useful
Hello all,
I am new to Sam7 arm controllers. I installed Yagato toolchain and Ide
on my pc. I dont know how to start coding for sam7 on yagarto. I have
AT91SAM7A3 controller board and SAN-ICE from atmel. Please tell me how
to start write code for this and how to add libraries and target mcu on
Yagarto.

Thanks & Regards
Mukesh

Author: James Lynch (lynchzilla)
Posted on:

Rate this post
0 useful
not useful
Hi Mukesh.

Take a look at this 200 page tutorial on the Atmel web site; "Using Open
Source Tools for AT91SAM Cross Development"

Here's the link:
http://www.atmel.com/dyn/resources/prod_documents/...

Cheers,
James P Lynch

Author: Mukesh Kumar (mukeshtalks)
Posted on:

Rate this post
0 useful
not useful
Hello James,

Greetings!

Thanks for your reply and sending the link of nice tutorial.

Mukesh
James Lynch wrote:
> Hi Mukesh.
>
> Take a look at this 200 page tutorial on the Atmel web site; "Using Open
> Source Tools for AT91SAM Cross Development"
>
> Here's the link:
> http://www.atmel.com/dyn/resources/prod_documents/...
>
> Cheers,
> James P Lynch

Author: Mukesh Kumar (mukeshtalks)
Posted on:

Rate this post
0 useful
not useful
Hello All,

Gretings!

how can i do the compile project for AT91SAM7A3-Ek project in Linux. I
downloaded gnu arm binary files on my pc. So please help for this how
can i start. is thier any other toolchain or library is need or only GNU
ARM binaties are sufficient.

Mukesh






James Lynch wrote:
> Hi Mukesh.
>
> Take a look at this 200 page tutorial on the Atmel web site; "Using Open
> Source Tools for AT91SAM Cross Development"
>
> Here's the link:
> http://www.atmel.com/dyn/resources/prod_documents/...
>
> Cheers,
> James P Lynch

Reply

Entering an e-mail address is optional. If you want to receive reply notifications by e-mail, please log in.

Rules — please read before posting

  • Post long source code as attachment, not in the text
  • Posting advertisements is forbidden.

Formatting options

  • [c]C code[/c]
  • [avrasm]AVR assembler code[/avrasm]
  • [code]code in other languages, ASCII drawings[/code]
  • [math]formula (LaTeX syntax)[/math]




Bild automatisch verkleinern, falls nötig
Note: the original post is older than 6 months. Please don't ask any new questions in this thread, but start a new one.