EmbDev.net

Forum: ARM programming with GCC/GNU tools not linking demo files


Author: Mike Sutton (Guest)
Posted on:

Rate this post
0 useful
not useful
I have installed the WinArm and as far as I am aware included all the
correct file paths. When I run make all for the LPC2106 blink switch I
get an error message
c:/winarm/bin/../lib/gcc/arm-elf/4.1.1/../../../../arm-elf/bin/ld.exe:
cannot find -lgcc

I have tried another exmple file for a SAM with the same result when
compiling make all after doing a make clean.

Any ideas please?
Mike Sutton

Author: Guest (Guest)
Posted on:

Rate this post
0 useful
not useful
Mike Sutton wrote:
> I have installed the WinArm and as far as I am aware included all the
> correct file paths. When I run make all for the LPC2106 blink switch I
> get an error message
> c:/winarm/bin/../lib/gcc/arm-elf/4.1.1/../../../../arm-elf/bin/ld.exe:
> cannot find -lgcc
>
> I have tried another exmple file for a SAM with the same result when
> compiling make all after doing a make clean.
>
> Any ideas please?
> Mike Sutton

Have unistalled and re-installed now Works.......

Reply

Entering an e-mail address is optional. If you want to receive reply notifications by e-mail, please log in.

Rules — please read before posting

  • Post long source code as attachment, not in the text
  • Posting advertisements is forbidden.

Formatting options

  • [c]C code[/c]
  • [avrasm]AVR assembler code[/avrasm]
  • [code]code in other languages, ASCII drawings[/code]
  • [math]formula (LaTeX syntax)[/math]




Bild automatisch verkleinern, falls nötig
Note: the original post is older than 6 months. Please don't ask any new questions in this thread, but start a new one.